![]() |
1. Remove lid from urn by twisting gently. |
![]() |
2. Remove inner (white) tube by twisting gently and place on a flat surface with the open end facing upwards. 3. Slowly fill the white tube with cremated remains (using a funnel if required). |
![]() |
4. Squeeze a generous line of glue approximately one inch below the rim around the inside circumference of the outer tube (the tube with the printed image and a hole in the base). |
![]() |
5. Line up the openings of both tubes and push the outer tube downwards slowly, to allow air to escape through the vent hole. Rotate as pushing. |
![]() |
6. Once the tubes are firmly in place, attach the label provided over the vent hole. PLEASE NOTE – it is important to attach the label at this point in the assembly to prevent any leakage of remains through the vent hole when the tube is returned to its upright position. |
![]() |
7. Turn the sealed urn over and replace the lid ensuring that the image is aligned. |
![]() |
8. To scatter cremated remains, remove the lid and push out the perforated disc. |